HAMMERLI INTERNATIONAL 208/211/214/215
- 208s Hammerli Vs Hammerli Xesse
- Hammerli 208 Magazine
- Hammerli 208 International Manual Transmission Engine
Sight Adjustments
Clockwise down.
Clockwise right.
1 click = 10mm @ 25m
Trigger Adjustments – Early Models
Slip Yoke Ford Replaces Dana 3-3-5431X 30/31 Spline. Slip Yoke Ford Replaces Dana 3-3-5981X 3-5981X 30/31 Spline. Slip Yoke Mustangs Recessed spline non-vented, Fits early Mustangs 27/28 Spline.
- 3200, 4200, 4300, 4400, 7300, 7400, 7500, 7600, 8500, 8600 SERIES Built After September 15, 2003 — ELECTRICAL CIRCUIT DIAGRAMS.
- Addeddate 2014-04-14 03:55:17 Identifier gunmanualHammerli208S Identifier-ark ark:/13960/t0gt86t34 Ocr ABBYY FineReader 9.0 Ppi 144 Scanner Internet Archive Python library 0.5.2.
Trigger Weight
Insert allen key through hole in trigger guard into the trigger adjustment screw.
Turn clockwise to increase trigger weight.
Trigger Stop
Strip pistol as described below.
Loosen locking screw, pull down trigger guard and adjust trigger stop screw (as indicated in photo). Clockwise to decrease back-lash.
Manual recommends back-lash should be no more than two to three tenths of a millimetre.
Trigger Adjustments – Late Models
For 208/211 serial numbered after 40335 or 214/215 after 67589.
Trigger Weight
Turn allen key 1.5mm (#1) clockwise to increase trigger weight.
Second Stage Travel (Sear Engagement)
This has been set at the factory and is not recommended to be adjusted. Turn screw (#2) clockwise to increase travel.
First Stage Weight
Takeup weight can be increased by turning allen key 1.5mm (#3) clockwise.
First Stage Travel
This can be lengthened by turning small screwdriver (#4) clockwise.
208s Hammerli Vs Hammerli Xesse
Stripping
Hammerli 208 Magazine
| Check pistol is unloaded and remove magazine. Leave slide in forward position. Loosen screw at rear (below rear sight) and remove the complete rear sight assembly by pulling the latter out backwards. |
| Remove the forward barrel weight by loosening the screw(s) and sliding forward. |
Remove the slide thus: Hold the pistol with the right hand, pull the trigger guard fully downwards and push this to the left with the right index finger. Now pull the slide back to the full extent of its travel, lift it up, and let it glide forward so as to leave the barrel freely. |